Thingiverse
Fusebox-Hypercube Hybrid for FLSUN cube hardware by SheldorTeConquor
by Thingiverse
Last crawled date: 4 years, 5 months ago
I've posted these parts since I know the adapter works, I linked the other parts that I used, will give a shopping list of the parts used (only about 30-50 bucks for bearings from amazon)
list of what's required:
3m GT2 belt (getting 5m wouldn't hurt)
16T GT2 idlers (8 total, preferably 6 toothed/2smooth)
M3 screws and (locking)nuts, you probably have extra, but I used ~10 additional 25mm long bolts for holding the idlers
Good things to also get:
LJ12A3-4-Z/BY PNP DC6-36V Inductive Proximity Sensor
"Brushless Turbine Blower Cooling Fan for 3D Printer" (works with mount, doesn't require an adapter)
12v v6 extruder clone kit
dont bother with a mosfet, they can kill your power supply.
be sure to configure marlin with your settings and features, I would use marlin-config as it is easy to use and see changes (https://github.com/akaJes/marlin-config/releases)
Essentially this combines the hypercube's x carriage with the fusebox 2's idler and mounting setup so it can reduce the needed material costs, be compatible with the 400mm x rails that dont work with a hypercube nor the fusebox due to them being too far away and the 500mm y rails that don't work with how the hypercube mounts their 300mm rails.
the new x rail adapter allows for the 400mm rails to be used on a fusebox setup, but at a distance apart that works with a hypercube carriage that allows for any hypercube accessory to be used on a FLSUN cube with Core XY at the least cost
*note I changed the CC to non commercial and share alike to allow for all parts to be posted at once, look into what parts you are printing from the project if you want to use it for such. (direct from hypercube parts, direct bracket parts, any remix of the fan duct or old sensor mount)
list of what's required:
3m GT2 belt (getting 5m wouldn't hurt)
16T GT2 idlers (8 total, preferably 6 toothed/2smooth)
M3 screws and (locking)nuts, you probably have extra, but I used ~10 additional 25mm long bolts for holding the idlers
Good things to also get:
LJ12A3-4-Z/BY PNP DC6-36V Inductive Proximity Sensor
"Brushless Turbine Blower Cooling Fan for 3D Printer" (works with mount, doesn't require an adapter)
12v v6 extruder clone kit
dont bother with a mosfet, they can kill your power supply.
be sure to configure marlin with your settings and features, I would use marlin-config as it is easy to use and see changes (https://github.com/akaJes/marlin-config/releases)
Essentially this combines the hypercube's x carriage with the fusebox 2's idler and mounting setup so it can reduce the needed material costs, be compatible with the 400mm x rails that dont work with a hypercube nor the fusebox due to them being too far away and the 500mm y rails that don't work with how the hypercube mounts their 300mm rails.
the new x rail adapter allows for the 400mm rails to be used on a fusebox setup, but at a distance apart that works with a hypercube carriage that allows for any hypercube accessory to be used on a FLSUN cube with Core XY at the least cost
*note I changed the CC to non commercial and share alike to allow for all parts to be posted at once, look into what parts you are printing from the project if you want to use it for such. (direct from hypercube parts, direct bracket parts, any remix of the fan duct or old sensor mount)