Thingiverse
Fusebox for prusa enclosure by JDP3d
by Thingiverse
Last crawled date: 4 years, 5 months ago
Needing a handy place to mount a fuse for the LED light strip for the prusa enclosure, I made a small space in the left-back top corner (corresponding with the placement of the power cables).
The smaller of the two added holes is for the two needed wires to solder to the fuse housing, the larger hole fits a panel mounted fuse housing, the hole was modeled to fit
this housing though it should be more than possible to scrounge up a compatible housing at your electronics store of choice.
I've included a modifier object in case you want to print the center column with full infill. That should give the part a bit more strength.
The smaller of the two added holes is for the two needed wires to solder to the fuse housing, the larger hole fits a panel mounted fuse housing, the hole was modeled to fit
this housing though it should be more than possible to scrounge up a compatible housing at your electronics store of choice.
I've included a modifier object in case you want to print the center column with full infill. That should give the part a bit more strength.