Furniture pipe foot insert for couch or futon by chungl 3d model
Warning. This content is not moderated and could be offensive.
smoking
3dmdb logo
Thingiverse
Furniture pipe foot insert for couch or futon by chungl

Furniture pipe foot insert for couch or futon by chungl

by Thingiverse
Last crawled date: 3 years, 1 month ago
This is a simple replacement for a furniture leg insert/end cap for a couch/futon/daybed that uses a pipe leg. It is designed to be functional, easy to print, and reasonably forgiving of printer tolerances.
This part was designed for a pipe with an inner diameter of 59mm* and extends the length of the leg by 3mm. It has a slight taper to make fitting easier, and notches to reduce filament usage and make a snug but flexible fit.
This is designed to be printed with 100% infill if it is to be used as a furniture foot. I've already removed most of the unnecessary plastic. At the very least, make sure the outer lip has a high number of perimeters, as this part will bear any load placed on the pipe.
*Note that the widest part of the taper is specified at exactly 49mm in this print, as most printers tend to over-extrude slightly. If your printer is perfectly dialed in or tends to under-extrude, and you happen to need exactly 49mm ID, you might need to resize else this may be a little loose.
OpenSCAD source is included and all parameters are easily edited at the top of the file.

Tags