Funny Bunny - Meme Rabbit by ModifiedDesigns3D

Last crawled date: 3 years, 2 months ago

LMAO! I'm sure many of you know this bunny. I just had to make it.
Some settings need to be activated (print between wall/that I did not have set)
I will work on a more universal setting friendly print.
Until then this is what I got..
To print multi colors you need to swap out filaments at a specific Z height. Assuming youre not on a raft so it goes as so
layers.....
0 - 4.4mm = belly/mouth color
4.6 - 4.8mm = body color
5 - 5.2mm = nose/hands color
5.4 = outline
Use your method of pausing print AFTER the section is complete.
Show some makes!! I know this bunny was in so many color combinations. Lets see what you got.
Ill work on making an easier print.I will update this!