Thingiverse
Functioning Switchblade by JohnyBoi
by Thingiverse
Last crawled date: 5 years, 3 months ago
Remixed from: https://www.thingiverse.com/thing:4394741
the original barely worked and you had to file loads of it down. With this remix you can print all the parts with a very high success rate and not have to do any post-processing apart from assembly.
(assembly video on original thing: https://www.thingiverse.com/thing:4394741 ) however i recommend 2 loombands or ones at that size
PETG works the best, but you can print all of the following parts in PLA successfully:
. Top case
. Bottom case
. Blade
. Button
Its works better if you print these parts in PETG:
. Slider
. Springs
All parts explained:
. Case2: the case on the bottom that houses the blade, slider, springs and top case
. Casetop2: top half of the case, goes in-between the button and slider
. Slider: holds a rubber band and moves the springs apart for the blade
. Comb blade: the blade but with a comb so its practical
. Original Blade: pointy blade with sharp edges
. Springs: both go inside the triangular gaps in the bottom case
. Button2: goes on the slider above the top case
Parts that may need changes in the slicer:
. Button - you may need to scale this to ~105% if it doesn't fit well
the original barely worked and you had to file loads of it down. With this remix you can print all the parts with a very high success rate and not have to do any post-processing apart from assembly.
(assembly video on original thing: https://www.thingiverse.com/thing:4394741 ) however i recommend 2 loombands or ones at that size
PETG works the best, but you can print all of the following parts in PLA successfully:
. Top case
. Bottom case
. Blade
. Button
Its works better if you print these parts in PETG:
. Slider
. Springs
All parts explained:
. Case2: the case on the bottom that houses the blade, slider, springs and top case
. Casetop2: top half of the case, goes in-between the button and slider
. Slider: holds a rubber band and moves the springs apart for the blade
. Comb blade: the blade but with a comb so its practical
. Original Blade: pointy blade with sharp edges
. Springs: both go inside the triangular gaps in the bottom case
. Button2: goes on the slider above the top case
Parts that may need changes in the slicer:
. Button - you may need to scale this to ~105% if it doesn't fit well