Thingiverse
Frame for Raspberry Pi by builtbybogus
by Thingiverse
Last crawled date: 4 years, 1 month ago
A barebone case for your Raspberry Pi!
Keeps all plugs and interfaces accessible and features wall mounting.
Print, remove supports and slide the Pi in from the side. Then screw it from the top with a M3 screw using the included washers. Use the hexagon shaped holes on the bottom side to insert M3 bolt nuts.
I punched out some rubber feet with a hole punch and glued them into the designated holes on the bottom. You can do that, too.
Attention: This case works only with the Raspberry Pi B (the one with holes in the PCB). Have fun!
Keeps all plugs and interfaces accessible and features wall mounting.
Print, remove supports and slide the Pi in from the side. Then screw it from the top with a M3 screw using the included washers. Use the hexagon shaped holes on the bottom side to insert M3 bolt nuts.
I punched out some rubber feet with a hole punch and glued them into the designated holes on the bottom. You can do that, too.
Attention: This case works only with the Raspberry Pi B (the one with holes in the PCB). Have fun!