FPV-Rover V2.31 (Tank)

Last crawled date: 4 years, 2 months ago

This is a remix version of the FPV-Rover V1.31 and FPV-Rover V2.0
with features:
speedy geared-motor with inner cooling fan and holes in sides of hull
increased clearance
raised front gear
reinforced hull
FPV-Rover V2.3 videoFirst test of solution
Print 2 body parts, glue them together and tighten them with 4 studs!
You can secure various batteries and any electronics(arduino,raspberry/orange pi, etc) inside by inserting M3 nuts into the grooves (step 10mm).
Do initially the caterpillars from 33 tracks, after several trips remove 1 track and leave 32 tracks in caterpillars .
The height of the useful volume of the body inside V2.3 - 44mm
Purchased parts:
m3x45(or 50)mm - 8pcs
m3 stud 120mm - 4pcs (I cut the stud 1m(3mm))
m3 nuts - 20pcs or more

3x1mm - 16pcs magnets (50pcs package)

8x bearings 6802zz for the main cog

16 x bearings 688ZZ for the small cog

2x 550 geared motor 12v 2300rpm Package A
2x ECS 160A XT60
1x or more 3s Lipo battery
1x BEC for protect rc-reciver: Easy tuned BEC or chiper BEC

1x Grease for Plastic Gear xy-2
Options

1x Servo 9g SG90
3x Fan 3010 12v
1x Tie for holder Lipo
1x 4CH Frsky Receiver
1x Metal Scalpel Knife
1x spare part 0.5M 10T 2.0 gear for gearbox 37GB
Parts to print (from FPV-Rover V2.31) (I printed with Infill: 30%)
1x body left v2.31 (see Print Setting Notes)
1x body right v2.31 (see Print Setting Notes)
1x inner track frame left v2.31
1x inner track frame right v2.31
1x outer track frame left v2.31
1x outer track frame right v2.31
1x fpv-cam-holder (I use Micro FPV camera holder for FPV-Rover)
1x front
1x back (3 version, choose which best for you)
(Rover_v1_x1_Back_V1
or Rover_v1_x1_Back_2x18650BAT_hold
or Rover_v1_x1_Back_AntennaHld )
8x small cog
2x main cog
2x rear main cog V2.3
2x small bevel V2.3
2x big bevel gear
66x track (recomend vertical print with 100% infill)
66x pins
1x top (v1,v2 with glue lock or v3 with screw locks)
(also you can use this base for mount EEZYbotARM MK2 )

1x set camera-led-mount
Options

1x led mount
2x inner protect long or short
1x holder servo (see photo)
1x Holder Battery V1 or 2x Holder Battery (see photo)
Holder 30mm Fan (see photo)
Cover 30mm Fan (see photo)
Upgrade 01:http://www.thingiverse.com/thing:1269962
Upgrade 02:http://www.thingiverse.com/thing:1700138
Upgrade 03:http://www.thingiverse.com/thing:1936491
Upgrade 04:https://www.thingiverse.com/thing:3686505
Upgrade 05Nerf Dart Launcher
Upgrade 06robotic arm EEZYbotARM MK2