Thingiverse
Foregrip and Handstop (No Hardware Needed)
by Thingiverse
Last crawled date: 5 years, 3 months ago
Some problems with the other similar ones are that the screw part didn't fit, it was extremely loose on the rail, and didn't go up high enough to actually grab the rail in the spaces. Also, it was just so bulky and so much bigger than one of the foregrips I own. They just felt unrefined.
I took the fixed screw version and scaled it down to actually fit on rails as well as modified the outside dimensions to match my foregrip. The screw was made longer to actually hold the rail. I also made a handstop version. After all, handstops are more tacticool than full foregrips.
I printed and tested the handstop but not the foregrip; however, the handstop is based off the foregrip, so it should work. Comment if it doesn't.
NO EXTERNAL HARDWARE NEEDED, unless something breaks, which is a huge plus, not my initial design though.
I took the fixed screw version and scaled it down to actually fit on rails as well as modified the outside dimensions to match my foregrip. The screw was made longer to actually hold the rail. I also made a handstop version. After all, handstops are more tacticool than full foregrips.
I printed and tested the handstop but not the foregrip; however, the handstop is based off the foregrip, so it should work. Comment if it doesn't.
NO EXTERNAL HARDWARE NEEDED, unless something breaks, which is a huge plus, not my initial design though.