Thingiverse
Ford Fiesta Sync 3 bracket
by Thingiverse
Last crawled date: 5 years, 3 months ago
If someone wants to add a sync 3 module to a Ford Fiesta Mk7/7.5 in Europe you can get most parts for a reasonable price locally or from the US. Dashboard and supports are needed from the US but it is very hard to come by the metal parts holding the Sync 3 module and screen in place onto the plastic supports from Ford. I recreated them for somebody else who wanted to do the same mod I did as I had the original part to measure.
The part is made into two parts as it is way easier to print. If it is too rough you might need some longer screws but in my test case the originals fitted. It is a bit thicker than the original metal part but there is enough space.
The two part version can lay mostly flat with some support. Your results may vary.
May require some longer screws, depending on print quality
v1. Hole are in the wrong place, this one is in use (with correct holes drilled)
v2. Holes are in the correct place. Easier to print as it requires less support structures. I have not tested it as I do not need it anymore
The part is made into two parts as it is way easier to print. If it is too rough you might need some longer screws but in my test case the originals fitted. It is a bit thicker than the original metal part but there is enough space.
The two part version can lay mostly flat with some support. Your results may vary.
May require some longer screws, depending on print quality
v1. Hole are in the wrong place, this one is in use (with correct holes drilled)
v2. Holes are in the correct place. Easier to print as it requires less support structures. I have not tested it as I do not need it anymore