Thingiverse
Flower with Leaves by bstnguy682975
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a remix from the two original designers who both did a really nice job capturing the natural beauty in their creations.
I shrunk the leaves to 50%, put a small hole in the base of the flower and used about 6" of filament for the stem.
The starter strip I used as filler to "solder" the pieces together.
Just a nice little pretty print!
Flower is Robotshop Purple PLA (it really looks magenta)
Stem and leaves are Makerbot Green
I shrunk the leaves to 50%, put a small hole in the base of the flower and used about 6" of filament for the stem.
The starter strip I used as filler to "solder" the pieces together.
Just a nice little pretty print!
Flower is Robotshop Purple PLA (it really looks magenta)
Stem and leaves are Makerbot Green