Thingiverse
FlashForge Creator Pro 2016 - Dual extrusion fan duct REMIX by marcos_bracho
by Thingiverse
Last crawled date: 4 years, 6 months ago
This remix only incorporates a small central rib in the air vents and main intake to the fan, to improve the manufacture without the use of internal supports in the parts not accessible.
The placed support was made manually with the own program of the printer FlashPrint, also a small angle was placed in the air outlet to direct a little better the flow of it.
Like the initial designer, I also place the solidWorks file so they can do any other type of improvement.
I put it in my flashforge creator pro 2016 and I work very well.
Annex images of the supports as guides and cuts where the nerve is observed that helps in printing without supports in the invisible parts.
Note: in my case I prefer to use base for the model, since in some cases a corner is usually raised while printing. If your printer has very good adhesion, the base will not be needed
Origin Filehttps://www.thingiverse.com/thing:1597507
The placed support was made manually with the own program of the printer FlashPrint, also a small angle was placed in the air outlet to direct a little better the flow of it.
Like the initial designer, I also place the solidWorks file so they can do any other type of improvement.
I put it in my flashforge creator pro 2016 and I work very well.
Annex images of the supports as guides and cuts where the nerve is observed that helps in printing without supports in the invisible parts.
Note: in my case I prefer to use base for the model, since in some cases a corner is usually raised while printing. If your printer has very good adhesion, the base will not be needed
Origin Filehttps://www.thingiverse.com/thing:1597507