Thingiverse
FlashForge Corner for 1-2mm (1/16) glass bed by Mdav801
by Thingiverse
Last crawled date: 4 years ago
Corners for the FFCP utilizing 6x9 1/16 glass bed.
*Updated as of 5/26 1010PM PST
Second STL uses a right angle for better bite and raised slightly above the bed. If using an active filament cooling fan, this will not get in the way as it is raised above the bed so slightly. I use this on the front left and rear right corners. Be sure to mount it on the opposite side of the nozzle wipe before printing.
*Updated as of 5/26 1010PM PST
Second STL uses a right angle for better bite and raised slightly above the bed. If using an active filament cooling fan, this will not get in the way as it is raised above the bed so slightly. I use this on the front left and rear right corners. Be sure to mount it on the opposite side of the nozzle wipe before printing.