Thingiverse
Fixture for alignment of the screws Z-axis Anet A8 by George164
by Thingiverse
Last crawled date: 4 years, 8 months ago
I didn't know how to correctly align the portal. To find a model if it is, I couldn't either. So I made two models. The model on the shaft I didn't test because I have a busy shaft.
Do autohome, then raise the portal to 80mm or more, set of this parts, drop the portal on the 15mm to clicks, raise, remove.
I hope everything is clear.
This model is for PLA. Use 1.03 or more for ABS. Use sandpaper on glass to both parts were the same size to 0.05mm.
Do autohome, then raise the portal to 80mm or more, set of this parts, drop the portal on the 15mm to clicks, raise, remove.
I hope everything is clear.
This model is for PLA. Use 1.03 or more for ABS. Use sandpaper on glass to both parts were the same size to 0.05mm.