Thingiverse
Fidget Spinner with interlocking cap by 3DPrinTek
by Thingiverse
Last crawled date: 4 years, 7 months ago
My take on the current fidget spinner hype.
Hope you like the design - the caps are interlocking with each other (but you need to print 2 of them of course).
My prusa i3 mk2 is a very precise machine - so you might scale it a bit to have a good fit on your printer.
the 625 version is for small bearings (often used in filament extruders) - they are 5x16x5mm
the 608 version is für 8x22x7mm bearings - which are - at least to my knowledge - standard sized skateboard and rollerskates bearings (correct me if i´m wrong here).
no support needed - prints fast and lokks awesome while printing.
NOTE: preview the caps in the slicer - there should be a little gap between the 2 "triangular" posts.
Hope you like the design - the caps are interlocking with each other (but you need to print 2 of them of course).
My prusa i3 mk2 is a very precise machine - so you might scale it a bit to have a good fit on your printer.
the 625 version is for small bearings (often used in filament extruders) - they are 5x16x5mm
the 608 version is für 8x22x7mm bearings - which are - at least to my knowledge - standard sized skateboard and rollerskates bearings (correct me if i´m wrong here).
no support needed - prints fast and lokks awesome while printing.
NOTE: preview the caps in the slicer - there should be a little gap between the 2 "triangular" posts.