Fan duct for BMG Aero Wind/Bondtech BMG Mount (JGMaker Artist-D) by TownDrunk

Last crawled date: 3 years, 1 month ago

This is a part-cooling fan duct for my BMG Aero mount for JGMaker Artist-D AND the BMG Aero Ender-3 / CR-10 mount by Adolf_Muffin that my extruder mount was remixed from. Both were generous enough to post their step files or my things would never have happened.
Should flow air better than original, BUT will require my updated BL Touch mounts, since this fan has a bigger foot print.
Print fan duct with supports with bottom flat side down. M3 hardware needed to attach to mount.
Print the duct with PETG and supports. The mounts can be printed in PLA if you prefer.
Update 4/15/2021: I extended the fan duct mount even lower to allow the bottom hole to be used with a volcano hot end. (v6) Enlarged the holes on the BL Fan and BL Touch mounts to work better with M3 screws.
Update 4/17/2021: Added BL Touch mount for Bondtech BMG extruder, which has no cooling fan.
Update 4/18/2021: Updated the Bondtech BL Touch parts and fixed the BL Mount for 4020 fan, which was offset the wrong way. Renamed the Bondtech parts to be similar to fan counterparts. Probe Offset will be -30.508, -27.713 for all variations. Z-coordinate will vary with Bondtech, Volcano, v6.
Update 4/20/2021: Added an experimental fan duct for opposite side.