Thingiverse

Fan Duct and Wire Guide/Cover with switch to permanently mount laser on Overlord Pro by chrisdug
by Thingiverse
Last crawled date: 4 years, 5 months ago
Updated 2/21/20116 - I am backing away from this - the cooling was too weak and the weight with the laser mounted was too great for the printer. To get good prints I had to slow it way down. I no longer have my laser permanently mounted - please take this into consideration before trying this....
This is loosely copied from http://www.thingiverse.com/thing:1017252 and https://tinkercad.com/things/8OpsRduVhCo. This is for the Overlord Pro to allow the mounting of the laser module permanently while still allowing the use of the fan for cooling the print. A 2 pole/3 positions switch is added between the connector on the main board and the fan/laser. This also helps the cables guide better and allows an anchor point for them with a wire tie. Please scale the cover at about 105% - it was just a bit tight.
This is loosely copied from http://www.thingiverse.com/thing:1017252 and https://tinkercad.com/things/8OpsRduVhCo. This is for the Overlord Pro to allow the mounting of the laser module permanently while still allowing the use of the fan for cooling the print. A 2 pole/3 positions switch is added between the connector on the main board and the fan/laser. This also helps the cables guide better and allows an anchor point for them with a wire tie. Please scale the cover at about 105% - it was just a bit tight.