Thingiverse
Face Shield Band by danilius
by Thingiverse
Last crawled date: 5 years, 4 months ago
This takes 11 minutes to print, and one minute to assemble.
More information will be published as it becomes available here: http://daniepstein.com/daniepstein/3d-printable-face-shield/
Requirements:
1 3D printed band
1 A4 or letter sized OHP transparent plastic sheet or equivalent
3 Staples (ideally use a staple gun)
Optionally two sticky foam pads for comfort
Staple the OPH sheet horizontally to three locations at the front of the band, as seen in the photos. Add two optional pads for comfort as seen in the photos. That's it.
More information will be published as it becomes available here: http://daniepstein.com/daniepstein/3d-printable-face-shield/
Requirements:
1 3D printed band
1 A4 or letter sized OHP transparent plastic sheet or equivalent
3 Staples (ideally use a staple gun)
Optionally two sticky foam pads for comfort
Staple the OPH sheet horizontally to three locations at the front of the band, as seen in the photos. Add two optional pads for comfort as seen in the photos. That's it.