Thingiverse
Fabrikator Mini V2 spool feeder and tool holder by toposolitario
by Thingiverse
Last crawled date: 4 years, 5 months ago
This spool feeder and tool holder is a small add on for the Fabrikator Mini V2. I've made this piece becouse I've found feeding problems when filament has too much tension due a too accute entrance angle into the pull chamber. That is even worse if your spool is almost depleted.
In fact, you can see some major feeding flaws in the tool holders caused by this (I was printing the first piece and left the printer unnatended) so filament became hard to pull.
Instead of creating a complex multi part piece with moving wheel and so... I've gone for the most simplistic desing to be printed one piece without supports. And I've added some tool holders for basic tools, pliers, and adjustment allen key.
Installation is pretty simple, remove the two corner screws, drop it in, and tighten the screws again.
In fact, you can see some major feeding flaws in the tool holders caused by this (I was printing the first piece and left the printer unnatended) so filament became hard to pull.
Instead of creating a complex multi part piece with moving wheel and so... I've gone for the most simplistic desing to be printed one piece without supports. And I've added some tool holders for basic tools, pliers, and adjustment allen key.
Installation is pretty simple, remove the two corner screws, drop it in, and tighten the screws again.