Thingiverse
extruder calibration by Cantankerous
by Thingiverse
Last crawled date: 4 years, 1 month ago
to calibrate esteps, its 120mm long with a step at 100mm
mark your filament at the tip which is 120mm and then use the step to check if 20mm remains after calibration, if its out measure with a ruler the difference and use maths to figure out your steps
mark your filament at the tip which is 120mm and then use the step to check if 20mm remains after calibration, if its out measure with a ruler the difference and use maths to figure out your steps