"Extended Tip" mod of Tronxy e3d Modular Hurricane 5015 and BLTouch wings by unnefer

Last crawled date: 3 years, 1 month ago

I've tried a number of e3d mounts for the Tronxy x5s and the CR10/Tronxy e3d Modular Hurricane mount is one of the best you can use - but it can cause a lot of grief for those new to 3D printing.
When using the wings for higher-flowing 5015 fans, too much air can blow on the hotend heatblock, which can drop the temp by 10-20c when the fans switch on at layer 2.
On a Tronxy x5s, when that, it cannot heat back up to the target temp in the default time limits set in Marlin 1.1.8 firmware and that leads to "thermal runaway" type errors.
I used Tinkercad to extend the tips of the "5015" and 5015_BLTouch" wings of the CR10/Tronxy e3d Modular Hurricane mount to better direct the air towards the tip of the hotend and away from the hotend heatblock.
I'm no expert with 3d design or tinkercad, but I needed a solution and this is the best I could do and it does what it needs to do :)
If you would like to remix this and make it better, the Tinkercad link is as follows:https://www.tinkercad.com/things/ghS1KSAZdsm-cr-10-x5s-hurricane-modular-mount-v6-extended-tip-wings/editv2?sharecode=ixfSAOJz_96wsE_X7BEFI0b6OrxkcxF9uhlrminX48Q=