Thingiverse
Exoslide Hemera Mount w/ BLTouch
by Thingiverse
Last crawled date: 5 years, 3 months ago
This is an E3D Hemera mount, inspired by Joe Casha's mount for the Ender, Tevo, Etc.
Very solid mount and easy to put together.
Printed w/ 50% infill with 5 wall layers, but I'm sure it would be fine with thinner walls and lower infill. I just wanted to be sure the mount would be stiff.
I did turn supports on for the Hemera mounts. Depending upon your printer, you may not need them. Be sure to set a decent relief from your side walls if printing in PETG.
Parts needed are as follows:
3 X 5mm M3 Button Head Screws
4 X 10-12mm M4 Button Head Screws
3 x Sqare M3 Nuts (Comes w/ Hemera)
Very solid mount and easy to put together.
Printed w/ 50% infill with 5 wall layers, but I'm sure it would be fine with thinner walls and lower infill. I just wanted to be sure the mount would be stiff.
I did turn supports on for the Hemera mounts. Depending upon your printer, you may not need them. Be sure to set a decent relief from your side walls if printing in PETG.
Parts needed are as follows:
3 X 5mm M3 Button Head Screws
4 X 10-12mm M4 Button Head Screws
3 x Sqare M3 Nuts (Comes w/ Hemera)