Thingiverse
EVGA RTX 3080 XC3 Endcap V2 by COLD_MARCUS
by Thingiverse
Last crawled date: 4 years, 10 months ago
Updated endcap to cover up the red outline "aka sad clown face" on EVGA RTX 3070, 3080, and 3090 graphics cards with the XC3 cooler. To install simply slide the bottom end over the card first (fan side) and then press on the top. Tab is supposed to rest against GPU shroud. Recommended to print with top facing GPU bed so that the text reads on the side and upside down. PETG or ABS suggested. Will not fit FTW coolers.
Changes compared to V1:
Made fewer and larger hexagons to improve printability and aesthetics
Added cutout for heatsink on top of card
Added tab to keep bottom of endcap from popping off
Repositioned side window to better align with XC3 text on card
Rounded endcap to reflect curvature of card
Changes to text on endcap
V2.1 fixes alignment of XC3 cutout and makes wall behind hexagons slightly thicker.
If endcap is loose on your card use 2.1 snug and sand the tab as needed
Changes compared to V1:
Made fewer and larger hexagons to improve printability and aesthetics
Added cutout for heatsink on top of card
Added tab to keep bottom of endcap from popping off
Repositioned side window to better align with XC3 text on card
Rounded endcap to reflect curvature of card
Changes to text on endcap
V2.1 fixes alignment of XC3 cutout and makes wall behind hexagons slightly thicker.
If endcap is loose on your card use 2.1 snug and sand the tab as needed