Thingiverse
ESS Goggles 30x10mm Fan and 9V Battery Housing by Mattastrophe
by Thingiverse
Last crawled date: 4 years, 3 months ago
A mount for a 30x10mm fan to vent my ESS goggles. The fan I had lying around was 12v, so I figured a 9v battery would be sufficient. Note that this is for the ESS Tactical SC Thermal goggles, an older model that has been out of production for quite some time, so this may or may not fit on the newer designs. Please leave a comment with the model you have if you make one and it does or does not fit.
This is still a work in progress. I plan to add strain relief and/or holders/clips for the wires, but that will come later, if at all.
The two barbed tabs fit into the top of the mask with some of the foam removed, and on either side there are holes to zip tie it in place to the mask through some of the aligned ventilation holes. The two halves of the fan housing may be held together in the front with zip ties or screws. I may make a version with a recess for nylock nuts later on.
For the version with the switch, I am using a rocker switch that I picked up from Microcenter, part 54-870 from NTE.
This is still a work in progress. I plan to add strain relief and/or holders/clips for the wires, but that will come later, if at all.
The two barbed tabs fit into the top of the mask with some of the foam removed, and on either side there are holes to zip tie it in place to the mask through some of the aligned ventilation holes. The two halves of the fan housing may be held together in the front with zip ties or screws. I may make a version with a recess for nylock nuts later on.
For the version with the switch, I am using a rocker switch that I picked up from Microcenter, part 54-870 from NTE.