Thingiverse
Espresso Distribution Tool ( WDT ) with magnetic Mounting by Sstteeffaann
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a WDT Tool to get rid of clumps in your Espresso.
The Mounting is magnetic. So if you want to have it with the mounting, you have to pause the Prints at the right hights and Insert a Magnet. Im using 15x4mm Magnets.
Take care of the right orientation!
The "needles" are just a 0.8mm steel wire. Just cut the lenght you want and give it a little 90degree bend. Insert them and tighten the bolt, so the wires are kept in place.
The Mounting is magnetic. So if you want to have it with the mounting, you have to pause the Prints at the right hights and Insert a Magnet. Im using 15x4mm Magnets.
Take care of the right orientation!
The "needles" are just a 0.8mm steel wire. Just cut the lenght you want and give it a little 90degree bend. Insert them and tighten the bolt, so the wires are kept in place.