Thingiverse
ESP8266 Lolin32 Case by xzentorzx
by Thingiverse
Last crawled date: 4 years, 2 months ago
This is a case I made for this board (or boards with the same footprint):https://de.aliexpress.com/item/ESP32-Rev1-wifi-bluetooth-board-based-ESP-32-4MB-FLASH/32814488554.html?spm=a2g0s.9042311.0.0.1ac84c4dBPpvN3
The lid is press fit and might be a tight one too. If its to tight sand off some of the bevel on the lid.
Supports are only needed for the access slot at the bottom. If you are confident in your printers bridging capabilities you might not need supports...
Change the orientation for it to lay flat on the buildplate.
The lid is press fit and might be a tight one too. If its to tight sand off some of the bevel on the lid.
Supports are only needed for the access slot at the bottom. If you are confident in your printers bridging capabilities you might not need supports...
Change the orientation for it to lay flat on the buildplate.