Thingiverse
ESP8266 bed of nails programer for ~16pin variant break out boards by mortomr
by Thingiverse
Last crawled date: 4 years, 2 months ago
Photo shows the base and insert assembled with the pogo pins and some very sloppy gel CA glue :/
the "cap" has a routing void for the wiring to exit from the alignment hole.
the "guide" was designed to drop in a bare module board and get you close to alignment but I don't think I'll end up using it.
Oops - You'll want to flip the cap piece and rotate the insert before printing obviously :)
Uses pins like this:http://www.ebay.com/itm/100Pcs-P75-B1-Dia-1-02mm-Length-15-85mm-100g-Spring-Test-Probe-Pogo-Pin-Tool-/321893993363?hash=item4af2608b93:g:NXYAAOSwhcJWH0ET
enjoy!
the "cap" has a routing void for the wiring to exit from the alignment hole.
the "guide" was designed to drop in a bare module board and get you close to alignment but I don't think I'll end up using it.
Oops - You'll want to flip the cap piece and rotate the insert before printing obviously :)
Uses pins like this:http://www.ebay.com/itm/100Pcs-P75-B1-Dia-1-02mm-Length-15-85mm-100g-Spring-Test-Probe-Pogo-Pin-Tool-/321893993363?hash=item4af2608b93:g:NXYAAOSwhcJWH0ET
enjoy!