Thingiverse
ESP12 (E/F) Programming Clamp by madtheos
by Thingiverse
Last crawled date: 4 years, 2 months ago
Very much a work in progress. No guarantees it will work.
The jaws are separate so they can be printed quickly in higher resolution.
No need to glue anything since you effectively tie them together with wires.
I used wires from an ethernet patch cable. Not sure about gauge.
On the one hand I support the move to Metric, but 2 mm pin pitch certainly does make the ESP12 hard to breadboard for programming. Hence this design.
The jaws are separate so they can be printed quickly in higher resolution.
No need to glue anything since you effectively tie them together with wires.
I used wires from an ethernet patch cable. Not sure about gauge.
On the one hand I support the move to Metric, but 2 mm pin pitch certainly does make the ESP12 hard to breadboard for programming. Hence this design.