Ender3 PSU Noctua NF-A9x14 cover by papcorp

Last crawled date: 2 years, 10 months ago

Ender3 NON PRO PSU cover that fits Noctua NF-A9x14 92mm fan.
IT WILL NOT FIT ON ENDER 3 PRO!!!
I had to design this myself as I couldn't fit a one that pleases me, each included useless space for stepdown board or were some stupid attachment that only fits the fan and is ugly.
There are 2 versions:
one hollow that has no flat surface at one end (this part is hidden under the PSU socket plastic part so it is not visible and you save a lot of time and fillament with hollow version (otherwise you need to print support under it or be very slow and have good bridging)

one that has nothing hollow, takes a bit more fillament and time

Fan fits perfectly without any issues.
Can be printed with PLA, it's not hot enough in PSU to have it deformed.
Has the OG vents plus honeycomb vents for fan.
Has labeling embossed in the PSU cover just like the OG cover.
Fan can be mounted with included noctua's rubber screws.
Can be printed with PLA, minimal infill.
Supports are needed if you printer is fast and is not godly with bridging.
If you use PWM (4pin) version of fan, you have to use yellow and black wire, cut it 'enough' and cut the original fan plug. Connect yellow of NOCTUA to red of original fan plug and black to black.