Ender3-Display-Stand-Ver4 by 873chi

Last crawled date: 3 years ago

A few months ago, Ver1 / Ver2 / ver3 were released one after another.
However, it was a fact that I was not convinced that the design was lax and there were mistakes.
I corrected the strange part and released it as ver4 because printing was successful with filament = PETG.
I made it in a grid pattern in consideration of printing cost.
Print information)
PETG:
① Temperature 230 ℃, 70 ℃
(2) Printing speed 50 mm / s
③ Infill 40%
④ Support YES
PLA:
① Temperature 200 ℃, 50 ℃
(2) Printing speed 50 mm / s
③ Infill 40%
④ Support YES