Thingiverse
Ender 5 Pro Filament holder 80mm spools by BSAPP-DESIGNS
by Thingiverse
Last crawled date: 4 years, 1 month ago
Summary
To be clear, you will need two 608ZZ bearings or any skate board wheel bearings they can found at any skate shop.
I have also relocated the spool roller to the lower horizontal rail to make the machine set in a small foot print .
As I found it difficult to print the roller in one piece without breaking the small pins on the outsides, I remixed Keleo's design "Roller with removable pin." to a 80mm spool version and printed that. I've included these files in the thing files section as of now. Also make sure to print roller with a skirt this help with it not falling of the build plate.
I really liked the original Filler, however the slide-in mechanism to attach the Filament Holder to my Creality Ender 3 was fairly wide. Also, my spool was quite far away from the metal Creality part on top of the extrusion. These two issues resulted in the spool leaning downwards and almost sliding off. Therefore I merged the two different parts together and made the whole shorter to better fit the 80mm width spools I use.
Post your makes! :)
Print Settings
Printer brand:
Creality
Printer:
Ender 5 pro
Supports:
Yes only on the FilHolder_80mm change the over hang angle so the supports are only where the roller sits.
Infill:
40%
Notes:
Print these standing upwards/vertical.
To be clear, you will need two 608ZZ bearings or any skate board wheel bearings they can found at any skate shop.
I have also relocated the spool roller to the lower horizontal rail to make the machine set in a small foot print .
As I found it difficult to print the roller in one piece without breaking the small pins on the outsides, I remixed Keleo's design "Roller with removable pin." to a 80mm spool version and printed that. I've included these files in the thing files section as of now. Also make sure to print roller with a skirt this help with it not falling of the build plate.
I really liked the original Filler, however the slide-in mechanism to attach the Filament Holder to my Creality Ender 3 was fairly wide. Also, my spool was quite far away from the metal Creality part on top of the extrusion. These two issues resulted in the spool leaning downwards and almost sliding off. Therefore I merged the two different parts together and made the whole shorter to better fit the 80mm width spools I use.
Post your makes! :)
Print Settings
Printer brand:
Creality
Printer:
Ender 5 pro
Supports:
Yes only on the FilHolder_80mm change the over hang angle so the supports are only where the roller sits.
Infill:
40%
Notes:
Print these standing upwards/vertical.