Ender 5 Front Rail Re-locater Brackets by NurseFarva

Last crawled date: 4 years, 3 months ago

Printed these brackets to move my front rail up out of the way so that I can view the first layer of my prints easily. These brackets should fit nicely although they may require a slight bit of hollowing out of the bolt holes. I used the two original black hex head bolts to attach the bar. I added two additional M5x12 bolts with corresponding nuts to reattach to the printer. I used my end caps to seal off the ends and make it look nice and clean. You can find that here https://www.thingiverse.com/thing:4586829. I printed the brackets at 100% infill to ensure stability and ensure that I wouldn't crush anything when tightening the bolts. Also, a friendly tip, you can drop the Allen key down the top whole to screw in the bolt that goes in the printer.