Thingiverse
Ender 4 PSU Switch by donminca
by Thingiverse
Last crawled date: 5 years, 5 months ago
wandering about thingiverse I did not find anything that could fit me for the space I have available and so I invented this little box.
I used all the recycling stuff, I had an old power supply for broken pc and I took the plug and switch (from the power supply I also took the filter, but only because I found them in), so if you buy them these are the specific names:
IEC 320 C14 (male connector)
6A 250V switch (because the 3A one is slightly smaller in size)
I ran the cables behind the power supply plate in the 4020 slot.
To screw it I used 2x M4 x 10 with t-nuts always found here on the site.
I used all the recycling stuff, I had an old power supply for broken pc and I took the plug and switch (from the power supply I also took the filter, but only because I found them in), so if you buy them these are the specific names:
IEC 320 C14 (male connector)
6A 250V switch (because the 3A one is slightly smaller in size)
I ran the cables behind the power supply plate in the 4020 slot.
To screw it I used 2x M4 x 10 with t-nuts always found here on the site.