Thingiverse
Ender 3 V2 - rpi 4 + Hyperpixel4 mount and case by plapointe6
by Thingiverse
Last crawled date: 4 years, 11 months ago
All you need to mount a Raspberry Pi 4 and an Hyperpixel 4 to your ender 3 V2.
Really usefull if you use Octoprint and/or Klipper.
I remixed the great case made by @superwoodle at : https://www.thingiverse.com/thing:4114747
If you made the V-Slot cover upgrade (https://www.thingiverse.com/thing:4579489), I included a new length to replace thoses you need to remove to install the screen.
You will only need two M3x5 (it can fit other length) to attach the two support leg under the RPI4 case. There is 4 hole under the case, these allow you to choose the orientation of the case. In fact, this allow to attach the screen in the other side of the printer if you mirror the case mount and screw the legs to the other set of hole avalaible.
2020-11-12 - Add .step files
Really usefull if you use Octoprint and/or Klipper.
I remixed the great case made by @superwoodle at : https://www.thingiverse.com/thing:4114747
If you made the V-Slot cover upgrade (https://www.thingiverse.com/thing:4579489), I included a new length to replace thoses you need to remove to install the screen.
You will only need two M3x5 (it can fit other length) to attach the two support leg under the RPI4 case. There is 4 hole under the case, these allow you to choose the orientation of the case. In fact, this allow to attach the screen in the other side of the printer if you mirror the case mount and screw the legs to the other set of hole avalaible.
2020-11-12 - Add .step files