Ender 3 Pro Left Big Drawer with Card Reader by the_holocron

Last crawled date: 3 years, 4 months ago

This is a remix that takes re-imagines the Left Big Drawer V2 and converts the small side piece into a mounting location for a MicroSD card extender.
This is intended to be used with this right side drawer system: https://www.thingiverse.com/thing:3416444
I'm also, like the original designer, using the Teaching Tech Rear Electronics Case: https://www.thingiverse.com/thing:3688967
However, I really dislike having the MicroSD card location in the back. While I use Octoprint for most of my printing, I occasionally use the MicroSD. This remix provides a mounting location for an extender, under the Y-Axis extrusion.
Still testing and have no yet printed. Designed around this MicroSD Extender: https://www.amazon.com/dp/B01D9J8KQE
The intent is that you can run the cable out the back of the case, then however you'd like to get to the rear case. The cable should stay in the side area, but you might want to tape it in place. It did not seem practical to design in some additional cable holders.