Thingiverse
Ender 3 Hemera Mount w/5015 fan, BLTouch, & Marlin config
by Thingiverse
Last crawled date: 5 years, 6 months ago
I found E3D's mount because the points for the screws were too thin. When assembling I found out that it also needed shorter screws than I could find so I killed two birds with one stone. I love the fan duct but I don't like adjustable mounts when using a BLTouch, I prefer somewhat repeatable offsets, and also found the duct sat too low even when adjusted as high as possible.
There were also some FW changes missing from E3D's guide so I thought I'd provide the ones for my setup.
This combines all of the parts and changes I used to get my Hemera working
Required hardware
Hemera 24v kit
Duct & Duct mount
2 x M4x25mm bolts
2 x M4 washers
2 x M4 nuts
5015 24v fan
2x M3x10mm bolts
Part A & B
4 x M3x6mm pan-head screws (to attach Hemera)
3 x M3x10mm pan-head screws
3 x M3 washers
3 x M3 square nuts
BLTouch mount
1 x M3 hex nut
If it seems like you're missing hardware during assembly use the hardware that came in the Hemera kit. I don't remember what all I used where from that kit unfortunately
12/28/19 - replaced Duct_Mount_Plate_w_ABL adjusted.stl, the previous version was off center
There were also some FW changes missing from E3D's guide so I thought I'd provide the ones for my setup.
This combines all of the parts and changes I used to get my Hemera working
Required hardware
Hemera 24v kit
Duct & Duct mount
2 x M4x25mm bolts
2 x M4 washers
2 x M4 nuts
5015 24v fan
2x M3x10mm bolts
Part A & B
4 x M3x6mm pan-head screws (to attach Hemera)
3 x M3x10mm pan-head screws
3 x M3 washers
3 x M3 square nuts
BLTouch mount
1 x M3 hex nut
If it seems like you're missing hardware during assembly use the hardware that came in the Hemera kit. I don't remember what all I used where from that kit unfortunately
12/28/19 - replaced Duct_Mount_Plate_w_ABL adjusted.stl, the previous version was off center