Enclosure joint for foam board enclosure by mduperly001

Last crawled date: 4 years, 1 month ago

I whipped this up in fusion 360 for an enclosure to hold my printer. As I am 13, I didn't have much to play around with so I went to Walmart and bought some foam boards because I figured if foam is used for insulation, wouldn't it be good enclosure material?(plus they were only like 3 bucks each) This joint will tightly hold foam boards together so they meet in a corner. I printed 8 of them (one for each corner of the enclosure) and then simply cut a foam board to fit on top. Very cheap solution for a decent enclosure. The best part about this is you can tear it down in minutes. This is really long. In your slicer cut it down so it only 65mm tall.