Thingiverse
Enclosure for the SBT11(A) based geiger counter from impexeris by michaelni
by Thingiverse
Last crawled date: 4 years, 5 months ago
This is a modified SBT11 / SBT11A geiger counter enclosure for the kit sold by impexeris. Its based on https://www.thingiverse.com/thing:2541156 by glassy.
This differs from the parent version by glassy by
leaving more space for the SBT11 tube (mine just did not fit in what my printer produced, so i made the space a tiny bit bigger in all directions)
Slightly changed the design so it prints without supports and has no large overhangs which printed but did not really look good. Its a bit more looking like a block as a result.
changed the hole for the on/off switch as i had nothing that fitted laying around.
added an additional groove in front of the tube to slide in a piece of paper or aluminum to shield alpha / beta
The battery cover is unchanged relative to the parent design.
The screw holes are the same as the parent design. 2 M3x16 or M3x18 screws/bolts fit in the 2 holes at the front. For the other 2 holes i used M2 screws which i cut and filed until they where not too long.
This differs from the parent version by glassy by
leaving more space for the SBT11 tube (mine just did not fit in what my printer produced, so i made the space a tiny bit bigger in all directions)
Slightly changed the design so it prints without supports and has no large overhangs which printed but did not really look good. Its a bit more looking like a block as a result.
changed the hole for the on/off switch as i had nothing that fitted laying around.
added an additional groove in front of the tube to slide in a piece of paper or aluminum to shield alpha / beta
The battery cover is unchanged relative to the parent design.
The screw holes are the same as the parent design. 2 M3x16 or M3x18 screws/bolts fit in the 2 holes at the front. For the other 2 holes i used M2 screws which i cut and filed until they where not too long.