Thingiverse
Embedded Systems Rack Raspberry PI 2 and 3 by jasonkuehl
by Thingiverse
Last crawled date: 4 years, 2 months ago
This is a custom rack mount for the Raspberry PI 2 and 3
Features :
1. Rack mount to standard 1u
2. Front facing power
3. Heat set screws, easy for attaching devices
4. Room to added add-ons for GPIO headers.
5. Super easy to remove and work with.
6. Very little support needed when printing.
7. A place for nuts on the bottom if case you don't have access to heat set screws.
8. A section in the front to add a label of what the device is.
9. Places at attach Velcro and tie wraps for add-ons.
Features :
1. Rack mount to standard 1u
2. Front facing power
3. Heat set screws, easy for attaching devices
4. Room to added add-ons for GPIO headers.
5. Super easy to remove and work with.
6. Very little support needed when printing.
7. A place for nuts on the bottom if case you don't have access to heat set screws.
8. A section in the front to add a label of what the device is.
9. Places at attach Velcro and tie wraps for add-ons.