Thingiverse
Elegoo Mars Scraper Drip
by Thingiverse
Last crawled date: 5 years, 10 months ago
I made this simple hook to snap onto the build plate clamp of my Elegoo Mars SLA printer.
This allows resin to drip off it, into the tank after removing the build and mixing / checking the tank for solid resin between builds.
Its fairly simple, but I do a lot of small builds and over time I have probably wasted a lot of resin wiping the scraper clean.
Also (despite always wearing gloves (honest...)) it keeps the handle from getting covered in resin.
I printed it on my FDM in PLA (not too sure how UV Resin will preform since it needs a little flexibility to snap on)
This allows resin to drip off it, into the tank after removing the build and mixing / checking the tank for solid resin between builds.
Its fairly simple, but I do a lot of small builds and over time I have probably wasted a lot of resin wiping the scraper clean.
Also (despite always wearing gloves (honest...)) it keeps the handle from getting covered in resin.
I printed it on my FDM in PLA (not too sure how UV Resin will preform since it needs a little flexibility to snap on)