Thingiverse
Elastomeric Coupling 0v0: 5mm stepper motor to 8mm threaded shaft by MiseryBot
by Thingiverse
Last crawled date: 4 years, 11 months ago
This thing is obsolete. Here is the next generation version: http://www.thingiverse.com/thing:7831
This thing is an experimental printable elastomeric coupling designed for a molded and cured-in-place rubber insert.
The rubber part is cured-in place RTV silicone sealer.
It has robust clamping, and should be well balanced if tightened evenly.
Heritage:
This is a variation of:
http://www.thingiverse.com/thing:7678
based on the suggestion there by JelleAtProtospace
=================================
AFTER I BUILD AND TEST THIS THING, I THINK IT FAIL.
Basically the silicone takes a long time to cure and is too soft. Overloads tend to make it want to go off center.
I do not recommend making this thing.
This thing is an experimental printable elastomeric coupling designed for a molded and cured-in-place rubber insert.
The rubber part is cured-in place RTV silicone sealer.
It has robust clamping, and should be well balanced if tightened evenly.
Heritage:
This is a variation of:
http://www.thingiverse.com/thing:7678
based on the suggestion there by JelleAtProtospace
=================================
AFTER I BUILD AND TEST THIS THING, I THINK IT FAIL.
Basically the silicone takes a long time to cure and is too soft. Overloads tend to make it want to go off center.
I do not recommend making this thing.