Thingiverse
Economic PSU support for Ender 3 Pro by FranAPM
by Thingiverse
Last crawled date: 5 years, 3 months ago
Economic low profile support with auto-lock for the power supply unit of Ender 3 Pro and maybe Ender 3.
It clips on the lower rail and holds the PSU at the base in order to reduce stress by overhanging weight in Z axis.
Installing instructions:
Just insert in rail and push the support against PSU base.
Pull PSU base upwards a little while pushing the piece until it fully slides and locks in place.
Troubleshooting:
If piece is loose either increase horizontal expansion or fill the gap with tape of your choice.
Piece is not supposed to be loose but tolerances may vary between printers.
It clips on the lower rail and holds the PSU at the base in order to reduce stress by overhanging weight in Z axis.
Installing instructions:
Just insert in rail and push the support against PSU base.
Pull PSU base upwards a little while pushing the piece until it fully slides and locks in place.
Troubleshooting:
If piece is loose either increase horizontal expansion or fill the gap with tape of your choice.
Piece is not supposed to be loose but tolerances may vary between printers.