EasyGlider Nose and Canopy by NickNitro

Last crawled date: 3 years, 6 months ago

Disclaimer
This is a Replacement Nose and Canopy assembly for the Multiplex EasyGlider.
I made this to replace the nose section on my easyGlider that was full of epoxy due to multiple repairs.
Since i lost the original canopy time Ago, i decided to also design the entire nose section in order to extrapolate a replacement Canopy.
I take multpile measures in order to create something that is the much similar to the real part as possible.
Due to the nature of this thing, i'm not able to test every single cut you might make, thus this is a work in progress. I also include full parts and some cutted files in order to help you.
File List
Full Parts
The following file are a single piece. you can use them and make smaller parts if your slicer permit it. there is a version with a motor mount (19x25 holes) and with right mount angles. I used a 30/35 Motor that fits well inside.
Please note that no Servo Mounting spots are currently be created.
EasyGlider_Nose_Motor_Full.stl
EasyGlider_Nose_Glider_Full.stl
EasyGlider_Canopy_Full.stl
Canopy Parts
The following list containt the 5 files that i created to print the Canopy. i make it thin with some structural border.
EasyGlider_Canopy_N0.stl
EasyGlider_Canopy_N1.stl
EasyGlider_Canopy_N2.stl
EasyGlider_Canopy_N3.stl
EasyGlider_Canopy_N4.stl
Nose Parts
The following list containt the 2 files that i used in order to replace the firs part of the EasyGlider Nose.
EasyGlider_Fuse_Mount.stl
EasyGlider_Motor_Mount.stl
Glider Version
The following files are less resistent but are lighter that the other when printed. they are suitable for a glider version.
EasyGlider_Fuse_Mount_Light.stl
EasyGlider_Nose_Cone_Light.stl