Thingiverse
e3d-lite6 cooling tube for Fusebox 1.4 by dotCID
by Thingiverse
Last crawled date: 4 years, 5 months ago
I was having clogging issues due to the hot end becoming too warm. In order to solve this I designed this cooling tube to improve the air flow to the cooling fins of the hot end.
Specifically made to fit the e3d-lite6 hotend and a 40x40mm fan. The cabling of the hot end should go around the carriage; if you guide it towards the back side of the printer it shouldn't get into the way of any parts.
I recommend using a bit of tape (I used electrical tape) to close any seam between the fan and the duct.
Specifically made to fit the e3d-lite6 hotend and a 40x40mm fan. The cabling of the hot end should go around the carriage; if you guide it towards the back side of the printer it shouldn't get into the way of any parts.
I recommend using a bit of tape (I used electrical tape) to close any seam between the fan and the duct.