Thingiverse
E-steps calibration chip by corecode
by Thingiverse
Last crawled date: 4 years, 7 months ago
This is a variation of Triffid Hunter's E-steps fine tuning suggestions.
Slice at 95% (rectilinear) infill.
Print and then abort the print once only the taller section is printing.
Compare top infill (100%), and infill (95%).
If the top infill has gaps between the lines, increase E-steps by 0.5%-1%.
If the 95% infill does not have gaps, reduce E-steps by 2%.
Repeat from 2.
Slice at 95% (rectilinear) infill.
Print and then abort the print once only the taller section is printing.
Compare top infill (100%), and infill (95%).
If the top infill has gaps between the lines, increase E-steps by 0.5%-1%.
If the 95% infill does not have gaps, reduce E-steps by 2%.
Repeat from 2.