Thingiverse
Duet3D PanelDue 7i angled Case Wall Mount by sbuerger
by Thingiverse
Last crawled date: 5 years ago
Big Thank You to kuhnikuehnast for the PanelDue angled case! This is the only case I could find on all of Thingiverse that perfectly fits the current (2019) version of the 7" display.
However, the case is intended to be mounted to aluminium profile poles, but I wanted to simply mount it to the wall beside the printer. So I made this simple wall mount that uses the case's existing screwholes.
Can be printed of whatever material you desire. Most likely (unless you have a perfect extrusion factor setting) you will have to re-tap the M5 thread. For one display you need two pieces.
Additional hardware needed are two M5 flathead screws, minimal length 10 mm (and whatever screws/wall plugs/nails you desire to mount to the wall).
Obviously, you need to have the case (https://www.thingiverse.com/thing:2999747) as well to make use of the wall mount.
Application is shown in the photos above.
However, the case is intended to be mounted to aluminium profile poles, but I wanted to simply mount it to the wall beside the printer. So I made this simple wall mount that uses the case's existing screwholes.
Can be printed of whatever material you desire. Most likely (unless you have a perfect extrusion factor setting) you will have to re-tap the M5 thread. For one display you need two pieces.
Additional hardware needed are two M5 flathead screws, minimal length 10 mm (and whatever screws/wall plugs/nails you desire to mount to the wall).
Obviously, you need to have the case (https://www.thingiverse.com/thing:2999747) as well to make use of the wall mount.
Application is shown in the photos above.