Thingiverse
Ducks Foot by
by Thingiverse
Last crawled date: 5 years, 4 months ago
Ducks Foot. Why ? I don't know.. just look like someting I should make,
I used Sculptris and Lightwave 3D to make the Mesh and Meshmixer to clean it up and make the stl. I Printed it on my newly updated printerbot simple (1405) I have not updated the firmware yet so i printed on a slightly unlevel printhead. thus the "stringy" bottom layer seen in the photo.
I used Sculptris and Lightwave 3D to make the Mesh and Meshmixer to clean it up and make the stl. I Printed it on my newly updated printerbot simple (1405) I have not updated the firmware yet so i printed on a slightly unlevel printhead. thus the "stringy" bottom layer seen in the photo.