Thingiverse
DSLR Shoulder Rig - Dual Parallel Std Clamp A, thing-o-matic printable by stevecooley
by Thingiverse
Last crawled date: 4 years, 1 month ago
This is a derivative of one of the parts from Flummer's DSLR shoulder rig. The "dual parallel standard clamp a" part is too wide to print on a thing-o-matic, so I chopped it in... roughly half... and added the finger joint to join the two parts together. I was curious to see if the stacked halves would print ok, and they do. the finish is a bit rough on the top half. Oh well.