Thingiverse
dropper post lever
by Thingiverse
Last crawled date: 5 years, 7 months ago
hi guys here is my second version of my 3d printed dropper lever this one uses a different bearing and only 2 bolts
1-m5x25mm flat head hex bolt https://www.ebay.com/itm/112745374051
1 m5 square nut https://www.ebay.com/itm/391701898577
1 6803 bearing https://www.ebay.com/itm/US-Stock-10pcs-6803-2RS-Deep-Groove-Rubber-Shielded-Ball-Bearing-17-x-26-x-5mm/391631118223?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
dropper cable clamp hardware
1 m4 square nut
1 m4x6mm allen bolt
2 m4 flat washers to clamp the cable
before installing you will need to remove the square chunk inside the main body, its just a support
1-m5x25mm flat head hex bolt https://www.ebay.com/itm/112745374051
1 m5 square nut https://www.ebay.com/itm/391701898577
1 6803 bearing https://www.ebay.com/itm/US-Stock-10pcs-6803-2RS-Deep-Groove-Rubber-Shielded-Ball-Bearing-17-x-26-x-5mm/391631118223?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
dropper cable clamp hardware
1 m4 square nut
1 m4x6mm allen bolt
2 m4 flat washers to clamp the cable
before installing you will need to remove the square chunk inside the main body, its just a support