Dragon Skull from Skyrim - Articulated by SkyFire428

Last crawled date: 3 years, 1 month ago

This is the Skyrim dragon skull by dmaccallum, but I edited it to have a opening/closing jaw. I made the joints very simple, and it turned out pretty good, even when printing it at half the size.
The skull and jaw are 2 separate pieces on this model, which may make it easier to print with a single-extruder printer, however I highly recommend using a dual-extruder printer and PVA for the support material to print this!
The ring part of the joint on the skull can be easily broken the smaller you print this, so if you do print it at any size less thatn 100%, be very careful with the joint. You may also have to sand the joint on the lower jaw a bit to make it fit into to ring part. I'll most likely improve the joints sometime soon, and when I do I'll update this.