Thingiverse
DRAFT: Optimizer for rain water diverter by elav
by Thingiverse
Last crawled date: 4 years, 5 months ago
DRAFT : NOT PRINTED YET!
This is a test, to see if I can divert ALL the water that ends up in a "standard" rain water diverter -- not just the amount that magically lands in the right spot.
Increasing the overflow level should also avoid wasting water.
The tricky part is getting it to divert as much water as possible, still allowing an effective overflow during a cloudburst.
Designed in OpenSCAD, you can change whatever you like. Adjust the 7 first lines, to fit your water diverter.
This is a test, to see if I can divert ALL the water that ends up in a "standard" rain water diverter -- not just the amount that magically lands in the right spot.
Increasing the overflow level should also avoid wasting water.
The tricky part is getting it to divert as much water as possible, still allowing an effective overflow during a cloudburst.
Designed in OpenSCAD, you can change whatever you like. Adjust the 7 first lines, to fit your water diverter.